Call to reach a local rooferNew Haven, CT
Call (833) 751-2102
Call to reach a local rooferCall any time(833) 751-2102
Serving New Haven County

Repairing slate on New Haven County's pre-war houses

Broken and slipped units are replaced one at a time by hand, and the reason they failed is diagnosed rather than sealed over.

  • Wind and storm damage
  • Ice dams after winter storms
  • Shoreline wind exposure

Get a fast quote

Fastest: call (833) 751-2102. Or send this and we call you back.

Slate Repair

Slate Roof Repair: what it covers

Quick answer

Slate repair is unit-by-unit work. A broken or slipped piece is cut free, the old fastener removed and a matched piece hung so the courses above are never disturbed. New Haven Roofing connects callers in New Haven and New Haven County with a local roofer who works on slate by hand rather than treating it as a shingle roof.

Slate Roof Repair illustration for New Haven, CT

A slate roof is a set of overlapping stone plates hung on nails, and it behaves nothing like a sealed field of asphalt. Each piece sheds water onto the piece below and relies on its neighbors for cover, so the failure of one unit is local and repairable. That is the great advantage of the material, and the reason a roof of this kind is worth keeping where the structure beneath it is sound.

This part of Connecticut has the houses to justify the craft. A town-hosted heritage page for Guilford records more than 675 dwellings predating 1911, described as among the largest such collections in New England, and the historic core of Branford dates to a settlement of 1638, with the Solomon Tyler House on East Main Street standing from about 1770. Older houses here commonly carry slate while postwar ones carry asphalt shingle; that is general practice rather than a measured split, and no reliable share has been published.

What usually fails on an old slate roof is not the slate. It is the nails, the flashing and the sheathing. Diagnosing which of the three has gone decides whether the job is a morning's work on a few units or a conversation about the whole plane.

Service area
New Haven & New Haven County
Availability
Call to reach a local roofer
Warning signs

Signs you need slate roof repair

Do not climb a slate roof, and do not let anyone else climb it without the gear to spread their weight. Stand clear of the eaves in a thaw, because slate releases snow in slabs and a sliding sheet of stone and ice is dangerous below. Pieces that have come down are sharp; wear gloves if you move them, and keep them, since a matching salvaged unit is worth more than a new one. Do not smear sealant into a gap to get through the week; it makes the proper repair harder. Call (833) 751-2102 and describe what came off.

  • Pieces of stone on the ground or in the gutter after wind or a thaw
  • A gap in a course that shows the dark line of underlayment or bare board behind
  • Units that have slid downward and are held only by the piece below
  • A chalky white bloom or a flaking, delaminating face on individual pieces
  • Many pieces slightly out of line on one plane, which points at nails rather than stone
  • Mortar missing from a hip or ridge where a bedded detail has weathered
  • Interior staining under a valley rather than under open field
Job stories

Typical jobs for slate roof repair

Typical job
Illustration: A typical slipped slate on a pre-war roof

A typical slipped slate on a pre-war roof

What homeowners notice
Two slates have come free over a winter and turned up whole on the path. The stone around the gaps looks sound, with no flaking at the edges and no cracking.
What we do
The condition is read as corroded fasteners rather than failing stone. The old nails are cut from beneath with a ripping tool, salvaged slates close in thickness and tone are slid into place, and each is secured from the joint below.
What to expect
The findings note that the covering itself is sound, list the two repaired positions and recommend a check of the remaining fasteners on the same slope before the next winter.

Options

Types and options for slate roof repair

Isolated broken or missing units

A limb, a hailstone, a dropped tool or an unwise footstep breaks a piece or two. The surrounding stone is sound, the nails hold, and the repair is a straightforward hand replacement. This is the best possible case and it is also the most common call, particularly after a storm brings branches down.

Nail-sickness across a plane

The fasteners corrode faster than the stone wears, so after many decades pieces begin to slip in no particular pattern. Replacing them one by one becomes an endless chase. A roofer will say plainly when a plane has reached that point, because the honest options then are a full strip and rehang of sound stone, or a different covering.

Valley, chimney and hip failures

Metal wears out long before stone does. An open valley that has thinned or split, a chimney apron that has lifted, or a hip whose bedding has washed out will leak while every piece of slate around it is in perfect condition. The slate is lifted, the metal replaced, and the stone reset.

Previous repairs that have to be undone

Old slate roofs collect well-meant interventions: tar smeared across a valley, strips of flashing face-nailed over a gap, pieces held by exposed fasteners straight through the face. Those have to be removed carefully, and the damage underneath is usually worse than the original fault was.

Need slate roof repair today?

Call any hour and explain what is going on. You get a clear price before any work starts.

Why is slate repaired rather than replaced with shingle?

Because the stone itself commonly outlasts several asphalt coverings, so a roof whose units are sound is an asset rather than a liability. Swapping it for shingle also changes the appearance of an older house, which matters to the house and, in a local historic district, to the review that applies to it.

There is a structural side as well. Slate is heavy, and the framing under an old slate roof was built for that weight. Taking it off does no harm structurally, but putting it back on a roof that has been shingled for decades is a different question, and so is adding a heavy simulated product to framing that was never sized for one.

The appearance question is formal in some places. New Haven's Historic District Commission reviews roofing material in local districts and has considered both like-kind replacement and simulated slate. If the house is in such a district, check with the commission before deciding, as the historic district roof work page describes.

How can you tell nail failure from stone failure?

Look at the pattern and at the pieces that come down. Stone that is failing flakes, delaminates and sounds dead when tapped. Nails that are failing leave sound pieces slipping out of line in scattered positions across the plane, often with a short length of corroded shank still in the wood.

The distinction decides the whole strategy. Sound stone on dead nails can be taken down, sorted and rehung on new fasteners, which keeps the roof that belongs on the house. Dead stone on good nails cannot be rescued by any amount of hand repair, because every piece replaced puts stress on brittle neighbors.

Mixed conditions are the common reality on a roof that is a century old. A roofer who has been on the plane can usually give you a rough proportion of sound pieces, which is the single most useful number in the conversation about what to do next.

  • Slipped but intact pieces scattered over the plane point to fasteners
  • Flaking faces, soft edges and a dull sound when tapped point to the stone
  • Damage grouped in one area points to impact or to foot traffic
  • Staining concentrated under a valley or a chimney points to metal, not to either

What harm does walking on a slate roof do?

A great deal. Stone is strong across its face and brittle at the edges and the fastener holes, so weight in the wrong place cracks pieces that were sound. Damage from a single careless visit is often discovered months later as a leak with no storm to explain it.

Crews that work on slate move on ladders, hooks, staging and roof boards that spread load away from the exposed stone, and they plan a route before they step. This is also why a roof of this kind should not be climbed by a homeowner, an antenna installer, a chimney sweep or anyone else without the right equipment and the habit of working on stone.

The hidden cost of foot traffic is a reason to get a written condition record when the roof is next inspected. The roof inspection report page covers what such a record contains and why buyers of older houses here ask for one.

What happens in winter on a slate roof?

Slate sheds snow in sheets once the sun gets at it, and it suffers the same eave icing as any other covering when attic heat melts snow that refreezes at a cold edge. The brittleness of the stone is what changes the response: ice should not be chipped off a slate roof.

Ice that forms behind a dam can back water up over the head lap of the lowest courses, and on an old roof there may be no membrane beneath to stop it. The result is staining at the top of an upstairs wall with no broken stone anywhere in sight.

The right fix is to deal with the heat and the air that cause the melting, and to clear ice with steam rather than tools. That work is described on the ice dam removal and repair page, and snow guards are sometimes added on a slate roof to stop whole sheets releasing over a doorway.

Our process

How our slate roof repair visit works

  1. Read the plane from the ground and from the attic

    Before anyone goes up, the roof is studied with binoculars from several angles and the underside is looked at where it can be reached. Slipped units in a scattered pattern suggest nail failure across the plane; damage grouped in one place suggests impact, a foot, or water running where it should not.

  2. Test fasteners and sheathing, not just stone

    A roofer checks whether pieces lift easily, whether the nails are corroded through, and whether the boards or lath behind still hold a fastener. Stone that is sound on a deck that is not cannot be repaired piecemeal, and saying so early saves a wasted visit.

  3. Match the replacement pieces

    Thickness, size and color are matched as closely as the roof allows, and salvaged units of the same vintage are used where they can be had. Weathered stone is never identical to new, so pieces are placed thoughtfully: matched material goes to the visible slopes and the nearest match to the back.

  4. Cut out and hang by hand

    A ripper is slid under the broken unit to shear its nails without lifting the course above. The new piece is hung on a hook or secured with a strap or a nail set high and covered, depending on the detail. The courses above stay undisturbed throughout, which is the whole point of the technique.

  5. Put the metalwork right

    Where a valley, a chimney apron or a hip is the real source, the metal is renewed with the slate carefully taken up and reset around it. Sealant across a valley is a holding measure at best; on a roof meant to last generations it is a repair that guarantees a return visit.

New Haven County

Why slate roof repair is different in South Central Connecticut

Guilford and Branford are where the oldest roofs in this service area sit. Guilford's Historic Town Center District around the Green holds more than 250 buildings, mostly late Colonial and Federal, and the Henry Whitfield House there dates to 1639. Roofs in that company are maintained rather than renewed, and the questions are about matching material and keeping original framing dry.

Within the city, older districts carry slate on houses that have since been divided into flats, which complicates access and scheduling more than it complicates the roofing. A rear addition, a porch stack or a later dormer often interrupts the original plane, and those junctions are usually where water is getting in rather than the open field of stone.

The wind events that trouble these roofs are the same ones that trouble every roof here, with a twist: falling limbs break stone instead of lifting it. The National Weather Service confirmed a 9.5-mile tornado track from Beacon Falls through Bethany to Hamden in May 2018, and in wooded towns a single branch coming down is enough to put a hole in a plane that was otherwise sound.

Related

Historic District Roof Work

Material and appearance are reviewed in a local district, so the sequence runs review first, order second, work third.

Roof Repair

A failed section of roof is found, scoped and rebuilt, rather than the whole covering being torn off.

Roof Inspection Report

A documented condition record: material, age indicators, defects by plane, and a separation of urgent work from planned work.

Guides

Read before you book

FAQ

Slate Roof Repair FAQs

Can missing pieces be replaced with asphalt shingle as a stopgap?

It is sometimes done in an emergency and it should not be left. A shingle patch sits at the wrong thickness, breaks the drainage pattern of the courses around it, and holds water against the stone above. If the roof has to be made safe quickly, a temporary cover over the area is the better interim step.

Where does matching slate come from?

Salvaged stone of a similar vintage, where it can be found, and new material cut to the same size and thickness where it cannot. Color never matches exactly on a weathered roof, so the usual approach is to put the closest pieces on the slopes people see and keep the rest for rear elevations.

Is a slate roof too heavy for an old house?

If the house was built with slate on it, the framing was sized for it. The weight question arises when a covering is changed: going heavier than the original needs the structure looked at, which is a carpentry assessment rather than a roofing one. A roofer will tell you when that assessment is needed.

How long does a hand repair take?

A handful of units is often a short visit once the material is in hand, and access is usually the longest part. Sourcing a match can add time. Valley or chimney metal work takes longer, because the slate around the detail has to come up and go back piece by piece.

Should the whole roof be inspected while someone is up there?

It is worth doing, since the access is already set up and a plane-by-plane look tells you whether you have scattered nail failure or an isolated fault. What you get out of it is a plan with a horizon rather than a series of unconnected call-outs.

WhatsApp