Call to reach a local rooferNew Haven, CT
Call (833) 751-2102
Call to reach a local rooferCall any time(833) 751-2102
Serving New Haven County

Replacing a skylight without inheriting its leak

A hole in the roof with a frame in it, replaced as a whole detail: curb, flashing and the courses around it.

  • Wind and storm damage
  • Ice dams after winter storms
  • Shoreline wind exposure

Get a fast quote

Fastest: call (833) 751-2102. Or send this and we call you back.

Skylights

Skylight Replacement: what it covers

Quick answer

Replacing a skylight means rebuilding the detail, not swapping a window. The unit comes out, the curb and the deck around it are checked and repaired, a flashing kit is fitted to suit the covering, and the courses are reset over it. New Haven Roofing connects New Haven and New Haven County callers with a local roofer.

Skylight Replacement illustration for New Haven, CT

A skylight is a deliberate hole in the roof with something transparent set in it. Everything about whether it leaks is decided in the few inches around the opening: the height of the curb, the way the flashing laps with the courses, and the condition of the deck it is all fastened to. The glass or the dome is rarely the problem.

That is why a leaking skylight is so often replaced rather than resealed. Sealant around a unit is the repair people reach for and it buys a season at best, because the frame, the curb, the covering and the deck all move at different rates and no bead bridges that for long. Rebuilding the detail is what settles it.

On older houses here there is an extra wrinkle. Many skylights on pre-war stock were added long after the house was built, into a roof that was never designed around them, sometimes with a shaft cut through a finished attic room. That history is usually visible as soon as the unit comes out.

Service area
New Haven & New Haven County
Availability
Call to reach a local roofer
Warning signs

Signs you need skylight replacement

Never step or lean on a skylight, and never assume one will hold weight. Aged plastic and older glazing fail suddenly and the fall is through the ceiling. If a dome has cracked, treat the whole unit as unsafe, keep people out of the room below where glazing could fall, and do not try to cover it from above yourself. Inside, keep electrical fittings away from water running down a shaft and switch off the circuit if it is close. Call (833) 751-2102 and describe what has failed.

  • Water running down the inside of the shaft, or staining at the bottom corners of it
  • A seal between glazing panes that has failed, leaving a milky or fogged look
  • Cracks or crazing in a plastic dome, often after a hail storm
  • A frame that has distorted, or a vented unit that no longer closes evenly
  • Sealant visible all around the outside of the unit, cracked or peeling
  • Draughts and cold radiating from the shaft in winter
  • Damp at the head of the opening where snow collects on the uphill side
Options

Types and options for skylight replacement

Replacing like for like

The existing opening is reused, a unit of the same size goes in, and the work is confined to the roof covering and the flashing. It is the simplest version, it needs no structural alteration, and it is usually what is wanted when the original unit has simply reached the end of its life.

Deck-mounted versus curb-mounted

Some units sit on a built-up curb and some mount directly to the deck with an integral frame. Which is appropriate depends on the pitch and the covering, and on a shallow roof a curb is often the better answer because it lifts the glazing clear of water and snow sitting on the surface.

Replacing a dome or a plastic unit

Older plastic units craze, yellow and go brittle with years of sun, and a hail storm will crack one that was already aged. These are frequently the ones that fail suddenly rather than slowly, and they often sit on low-slope roofs where the curb height matters most.

Removing a skylight altogether

Sometimes the right answer. An old unit over a stairwell that leaks, has no useful daylight value and sits in a roof about to be replaced can be taken out and the roof closed in properly. It is a cheaper and more permanent outcome than a fourth attempt at making it watertight.

Skip the guesswork. Call for a straight answer.

Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what skylight replacement should cost.

Why do skylights leak at the top rather than the bottom?

Because the uphill side is where water and snow collect. Everything running down the slope arrives at the head of the unit and has to be split around it, so if the head flashing is short, badly lapped or buried under drifted snow, that is where water gets in first.

This is also why curb height matters. On a shallow roof, or on a roof that holds snow for weeks, a unit sitting low in the plane is standing in water each time it thaws. Lifting the glazing on a curb takes the seal above the waterline.

Winter makes the geometry worse. Snow drifts on the uphill side of anything standing out of a slope and the meltwater behind it has to find a way past, which is the same mechanism that makes a wide chimney need a cricket. The eave version of that problem is on the ice dam removal and repair page.

How do you tell condensation from a leak?

Timing and pattern. Condensation appears in cold weather regardless of rain, is worst in bathrooms and kitchens, and shows as droplets across the inner face of the glazing. A leak follows rain or snowmelt, and typically runs from one point at the head or a corner.

A failed sealed unit is a special case: the glazing fogs between the panes and the unit no longer insulates well, so it runs cold and collects moisture. That is a reason to replace the unit itself rather than to rework the flashing, and it is easy to confirm visually.

The humidity in the room matters too. Where a skylight sits over a shower and the extract fan is weak or discharges into the attic, moisture is being delivered to the coldest surface in the room. Fixing the ventilation can stop the dripping without touching the roof, as the attic ventilation for ice dams page describes.

  • Water only after rain or snowmelt, from a point source: suspect flashing
  • Water in cold weather with no rain, spread across the glass: suspect condensation
  • Milky or fogged glazing between panes: the sealed unit has failed
  • Staining at the bottom corners of the shaft with a dry head: often condensation running down

When should a skylight be replaced with the roof?

Whenever both are near the end of their lives, because the flashing is part of the covering and cannot be renewed properly without disturbing it. Putting a new roof around an old skylight leaves the weakest point untouched and makes the eventual replacement a second disruption.

Cost aside, the quality argument is simple: during a replacement the deck is exposed, the courses are off and the detail can be built in the correct order from the deck up. Doing it later means working back into a finished roof, which is possible but never as clean.

This is one of the questions worth raising when a replacement is being scoped, along with chimney flashing and the low-slope areas. The roof replacement page sets out what else belongs in that conversation.

Does a skylight need review or a permit?

It can. Changing the size of an opening involves framing, which is a structural alteration, and the local building department is the place to ask what that requires. If the house is in a local historic district, a new or altered opening changes the appearance of a roof plane.

New Haven's Historic District Commission reviews roofing material in local districts, so any change visible from the street is a conversation to have before ordering, not afterward. A unit on a rear plane is a different matter from one cut into a street elevation, and the commission is the body that decides.

On the permit side, the honest answer is to ask. Aggregator sites disagree about what is required and what it costs in this area, so nothing of that kind is quoted here. The Department of Consumer Protection has advised confirming with the local building official that a permit was pulled where one is needed.

Our process

How our skylight replacement visit works

  1. Work out whether it is a leak or condensation

    Water inside a shaft is not always coming through the roof. A single-glazed or failed unit over a bathroom or kitchen collects condensation on its inner face, which runs down and stains the corners exactly as a leak would. Which one it is changes the whole answer, so it is settled first.

  2. Inspect the curb, the deck and the surrounds

    The roofer looks at how the unit sits: whether there is a curb at all, how high it stands above the covering, and whether the deck around the opening is sound. Long-term leaks rot the deck at the lower corners first, and that has to be dealt with before a new unit goes in.

  3. Choose a unit that suits the roof

    Pitch, the size of the existing opening, the rafter spacing and whether the unit needs to open all narrow the choice. Matching the existing opening avoids structural work; changing size means cutting or altering framing, which is a bigger job and may involve the local building department.

  4. Remove and rebuild the opening

    The old unit and its flashing come out, the courses around it are lifted, and any soft decking or rotten framing at the opening is cut back and replaced. This is the stage that decides the life of the new installation, and it is also where the cost of years of slow leaking becomes visible.

  5. Fit the unit with a proper flashing kit

    The flashing is a set of pieces designed to lap with the covering: an apron below, step pieces up the sides, a head flashing above. On a slate roof the detail is made in metal to suit the stone. Nothing in the assembly should depend on sealant to keep water out.

  6. Reset the covering and finish inside

    Courses go back over the flashing in the right order, and the shaft is made good inside where the lining has been disturbed. Insulating the shaft while it is open is worth doing, since it is the one moment the cavity is accessible and the shaft is otherwise a cold chimney in the middle of a ceiling.

New Haven County

Why skylight replacement is different in South Central Connecticut

Skylights on older houses here are usually later additions, cut into roofs built long before anybody expected them. Well over a third of the city's homes predate World War II by its own housing chapter's account, and on those houses a skylight often lights a stairwell or a converted attic room through a long shaft. The age of the installation, rather than the age of the house, is what decides how much repair work is found around the opening.

The weather here is hard on glazing details in two different ways. Nor'easter and winter-storm season drives rain horizontally at the head of a unit and leaves snow sitting on its uphill side for weeks. Summer thunderstorm and tropical season brings the kind of short, violent rain that finds any lap in the wrong order, and the occasional hailstone big enough to crack an aged plastic dome.

On three- and four-unit houses, which this city has more of than any other in the state, skylights often appear on low-slope porch or ell roofs rather than on a pitched plane. Curb height is the critical measure there, because the surface around the unit holds water by design, and the detail is really a low-slope detail rather than a shingle one.

Related

Roof Replacement

The old covering comes off, the deck and the edges are put right, and the roof is rebuilt as an assembly rather than a surface.

Flat and Low-Slope Roof Repair

A surface where water sits rather than runs, repaired at its seams, outlets and upstands rather than course by course.

Hail Damage Roof Inspection

An uncommon event here, checked carefully: impact marks are told apart from wear, and findings are recorded with dates.

Guides

Read before you book

FAQ

Skylight Replacement FAQs

Can a leaking skylight be resealed instead of replaced?

It can be sealed, and that is a holding measure rather than a repair. Where the flashing is wrongly lapped, the curb is too low or the deck has gone soft, no amount of sealant addresses the cause. Rebuilding the detail is what stops the annual return of the same stain.

Will a new skylight fit the existing opening?

Often yes, if the opening is a standard width between rafters, which is the usual case where the original was fitted sensibly. Where it is not, either the unit is made to suit or the framing is altered, and the second option turns a roofing job into a structural one.

Do skylights always leak eventually?

No, but they are a detail rather than a plain surface, so they depend on being built correctly and on the covering around them being sound. A well-detailed unit on a maintained roof can go for decades. A poorly flashed one will leak in its first bad storm.

What about the shaft inside?

It is part of the job worth thinking about. An uninsulated shaft is a cold tube through the ceiling, which encourages condensation and loses heat, and the only convenient moment to insulate it is while the unit is out and the lining is open.

Can an opening skylight be replaced with a fixed one?

Usually, and it is often a sensible simplification, since the moving parts and seals on a vented unit are what fail first. Where the skylight is providing ventilation to a bathroom or a stairwell, that function needs replacing another way before the unit is fixed shut.

How soon can someone look at it?

Phones are answered 24 hours a day, every day, and a visit the same day is possible when a technician is free. If glazing has broken or a dome is open to the sky, say so on the call, because covering the opening is the immediate job and the replacement follows.

WhatsApp