Why do shingle roofs fail at the edges first?
Wind does not peel a roof from the middle. It gets under an edge, lifts it, and works along the course. Rakes, eaves and ridges are therefore the places where a roof is won or lost, and the starter course, the edge metal and the nailing pattern are what hold those lines down.
Air moving over a sloped roof creates suction near the edges and the ridge rather than pressure. A tab whose seal has aged, or one that was never sealed because the starter was missing, has a free corner for that suction to catch. Once a single tab folds back, the one above it has an exposed edge and the sequence continues.
This county gets the wind to test it. The National Weather Service names soundfront Milford and East Haven among the places with the most widespread major damage in the October 2012 hurricane, and in August 2026 an overnight straight-line wind event produced a gust of 103 miles per hour recorded at Lighthouse Point Park, with the Weather Service classification still provisional at the time. Roofs on the shoreline streets live with that.
What does ventilation have to do with the covering?
A shingle is cooled from below as much as from above. An attic that cannot exhaust warm, moist air bakes the covering from the underside in summer and, in winter, melts roof snow unevenly so meltwater refreezes at the eave. Both shorten the life of the roof you have just paid for.
Balance is the idea: intake low at the soffit and exhaust high at the ridge, so air moves continuously under the deck. Many postwar houses here have had insulation blown into the attic floor at some point, which is good for heating bills and bad for soffit intake if it was pushed into the eaves and nothing was done to hold it back.
This is why a replacement is the natural moment to sort venting out. The deck is open, the ridge is accessible and the soffits can be checked from above. The mechanics are set out on the attic ventilation for ice dams page, and the winter consequence on ice dams in New Haven County.
- Intake at the soffit, clear of insulation, along the full length of the eave
- Exhaust at or near the ridge, sized to match the intake rather than exceeding it
- Baffles where blown insulation would otherwise block the air path
- Bathroom and kitchen fans ducted outside, never into the attic space
Does the time of year change the installation?
Yes, because the sealant strip on a shingle is activated by warmth. In cold weather the courses will not bond on their own, so the roof relies entirely on its nails until the sun does the work in spring. A roofer may hand-seal courses at the edges to bridge that gap.
That is a practical reason why replacements concentrate in the warmer months here, between nor'easter and winter-storm season at one end and the worst of summer heat at the other. It is not a rule against winter work; a roof that is failing does not get to choose its season. It does mean a winter installation is detailed differently.
Heat has its own issues. A very hot roof is unpleasant and slow to work on, and material is more easily scuffed under foot. Early starts and slope-by-slope sequencing are how crews deal with it.
How does a two- or three-unit building change the job?
Mostly in logistics and in the roof shape. Multi-unit houses here often pair a pitched main roof with a low-slope rear porch stack, so two systems meet and the junction between them has to be detailed. Access, staging and notice to every household are the other differences.
The pitched planes are ordinary shingle work. The low-slope sections are not, and putting shingles on them because the rest of the roof is shingled is a common way to create a leak. Those areas are covered with a membrane system, which is the subject of the flat and low-slope roof repair page.
New Haven has the highest share of three- and four-unit houses of any Connecticut city according to its Vision 2025 housing chapter, so this mixed-roof situation is common rather than exotic. A scope on such a building should name each roof area separately.