Roof Repair
A failed section of roof is found, scoped and rebuilt, rather than the whole covering being torn off.
The work falls into a few families: tracing and repairing leaks, clearing ice and fixing what it broke, recording storm damage, replacing a covering that has reached its end, and the detail work at chimneys, valleys, skylights and gutters. Each starts with an inspection and ends with a written scope.
Fastest: call (833) 751-2102. Or send this and we call you back.
Which service you need is often not obvious from the symptom, and it does not have to be. A stain on a ceiling can be a valley, a chimney joint, an ice dam or a seam on a low-slope rear section, and those are four different repairs. The inspection decides, not the phone call.
One visit can cover several items. On these houses a leak at a chimney and ice at the gutter frequently share a cause in the attic, so the findings list each item with its own location and recommendation, and the work can then be combined or staged as you prefer.
A failed section of roof is found, scoped and rebuilt, rather than the whole covering being torn off.
The old covering comes off, the deck and the edges are put right, and the roof is rebuilt as an assembly rather than a surface.
The standard covering for the area's postwar houses, laid so that nailing, sealing and ventilation all do their part.
Broken and slipped units are replaced one at a time by hand, and the reason they failed is diagnosed rather than sealed over.
Material and appearance are reviewed in a local district, so the sequence runs review first, order second, work third.
Ice at the eave is melted off rather than chopped off, then the water path and the damage behind it are dealt with.
Air sealing and balanced venting stop the roof deck being warmed from below, which is what starts an ice dam.
Torn, lifted and punctured roofs are made watertight first, then repaired back to a working assembly.
A plane-by-plane look at a roof after a storm, written up with photographs so you can decide what to do next.
An uncommon event here, checked carefully: impact marks are told apart from wear, and findings are recorded with dates.
The entry point is traced rather than guessed, and the junction that failed is rebuilt instead of being sealed over.
The metal around a chimney is renewed as a set, with counterflashing let into the masonry rather than sealed onto it.
A surface where water sits rather than runs, repaired at its seams, outlets and upstands rather than course by course.
Troughs, joints, hangers and outlets put back in working order so the roof drains instead of soaking the eave.
A hole in the roof with a frame in it, replaced as a whole detail: curb, flashing and the courses around it.
A temporary cover, fastened and lapped so it stays put, bought to keep water out until the repair can be scoped.
A documented condition record: material, age indicators, defects by plane, and a separation of urgent work from planned work.
| Service | Typical range | Details |
|---|
Estimates only. Your price is confirmed on site before work starts. See the full price guide.
Call any hour and explain what is going on. You get a clear price before any work starts.
Describe the symptom and let the inspection name the work. If you are seeing water, start with leak tracing. If you are seeing ice at the eave, the attic matters as much as the roof. If a storm has just passed, an inspection and a record come first.
Not interchangeably. Slate is hand work with its own tools and its own access methods, and it is done by someone who works in it regularly. A house with slate on the main roof and shingle on a rear addition may need both approaches on one job.
No figures are published for this area. Each job is scoped after the roof has been measured and the deck considered, and the pricing page sets out what that scope should name so you can compare two of them properly.
Yes, and they are a large part of the work here, because the city has the state's highest share of three- and four-unit houses. Those roofs are inspected differently: the seams, the outlets and the perimeter matter far more than the field.