What makes a report useful rather than decorative?
Specificity. A sentence saying the roof is in fair condition tells nobody anything. A note saying the rear slope has lost granules across its lower third, with three cracked tabs photographed near the valley and no ice barrier visible at the eave, is something a reader can act on.
Locations matter as much as findings. An item that says which plane, how far up it, and which side of which chimney can be found again by a different roofer months later. An item that just says flashing defective cannot.
Honesty about limits is the other mark of a good document. Nobody can see under the covering without lifting it, and a report that states clearly what could not be determined is more valuable than one that implies complete knowledge of a roof nobody opened.
- Material and layer count, with how the count was established
- A separate condition note for each plane and each junction
- An attic section covering staining, framing, sheathing and ventilation
- Dated photographs tied to locations, not a general gallery
- Two clearly separated lists: now and later
- A plain statement of anything that could not be assessed and why
How is remaining life estimated?
From the behavior of the material rather than from a date. Granule cover, whether tabs crack when lifted, how fasteners are holding, the condition of the edges and ridge, and what the attic shows all contribute. The result is a range and it is stated as a range.
This is why nobody should give a single number. Two roofs of identical age in the same town can be years apart in condition depending on orientation, ventilation, how well the original work was done and how many storms found their weak points. A report that says eight to twelve years is being more truthful than one that says ten.
Ventilation deserves its own mention in any estimate, because an unvented attic bakes the covering from beneath in summer and drives ice formation in winter. Two otherwise identical roofs will differ markedly on that factor alone, as the attic ventilation for ice dams page explains.
What does a report on an older house look for in particular?
Layer count, the condition of plank sheathing, previous repairs made in the wrong material, junctions created by later alterations, and whether the eaves have any protection against backed-up water. These are the findings that decide what a future replacement involves.
Alterations are the richest source of defects. A dormer added decades after the house was built, an ell with its own roof, a porch converted to a room: each created junctions that were detailed once, often indifferently, and have been patched since. Those are inspected harder than the original planes.
Material history matters too. Older houses here commonly carry slate while postwar ones carry asphalt shingle, as a matter of general practice rather than any measured share, and a house may have both after decades of partial work. A report should say which is where, as the guide on slate or asphalt on a pre-war house discusses.
How does a report sit alongside insurance and registration checks?
It gives you a dated baseline of condition, which is useful if the roof is later damaged in a storm. It says nothing about coverage, which is a matter for your policy and your insurer, and it is not a substitute for checking who is doing the work.
A notice from the Connecticut Insurance Department in March 2024 said cosmetic roof discoloration and streaking do not support non-renewal of a policy, which occasionally matters when a roof is being judged from aerial photographs rather than in person. A written, dated condition record is a reasonable response to that kind of assessment.
Separately, the Connecticut Department of Consumer Protection registers home improvement contractors and said in 2025 that roofing companies must be registered with it, with a lookup at elicense.ct.gov. Whoever writes your report and whoever does the resulting work are both worth checking there.
Is this the same as a storm inspection?
The method overlaps, the purpose does not. A storm inspection is looking for damage attributable to a particular event on a particular date. A condition report is looking at the roof as a whole, with age and wear as the subject rather than an exclusion.
In practice a roofer doing either will notice the other, and a good storm inspection notes general condition while a good condition report notes any apparent storm damage. What differs is the framing and what the document is for.
If a storm has just passed and you need the damage recorded against that date, the storm damage roof inspection page describes that work and the caution the state advises about doorstep offers afterward.